How to install a basketball wooden floor?
1. Install ground leveling and shock-absorbing pads.
Concrete floor. The wall (installation of skirting boards) is leveled with professional instruments and the site is cleaned up. Install the leveling pad at the reference point and install the elastic pad on the leveling pad.
2. Keel installation.
According to the requirements of the center distance of the drawing, on the premise of eliminating defects, the length is reasonably determined, and the keel is spliced. Check the flatness of the keel and mark it. After the test, the part is flattened. After the keel is installed, two measures should be taken.
Sports wood floor structure
3. Fur floor installation.
Rough floors are thick on both sides, with the ends aligned. According to the design requirements of the drawings; pay attention to the end of the rough floor falling on the keel, do not hang; the width is uniform, the seams are staggered; there is a gap of 1-2 cm between the rough floors. Rough floors are nailed to the joists and have two pest-proofing measures.
4. Lay moisture-proof film.
Choose moisture-proof and non-toxic non-woven fabrics, lay a moisture-proof layer along the direction of the keel, and the surface is non-porous. Eye. Tear, otherwise it should be repaired, moisture-proof and sound-absorbing, greatly improving the use of the floor.
5. Panel. Install baseboards and vents.
The central floor is connected in blocks along the direction of the central keel, and the surface is at the same height as the design standard and is located in the center. Once qualified, reinforce from both sides without damaging the floor during reinforcement. There should be a 3-5mm gap between adjacent floors during laying. Finally, install baseboards and vents, and clean the site
