The skirting board is the part of the sports wood floor system against the wall and plays an important role in the sports wood floor. Therefore, the construction personnel need to pay attention to the skirting board when installing the sports wood floor. The following editor will introduce the construction skills of the sports wood floor in detail during the installation process. .
1. Direct paste method The direct paste method is to apply floor glue to the skirting board in the form of dispensing, and the point distance is about 40-50cm.
2. Fixing the skirting board with nails There are two ways to fix the skirting board with nails: the wedge method is generally used; the other is directly nailed into the wall with cement nails.
Three, wedge method
1: Drill several holes with an impact drill at the root of the wall, usually one hole about 80cm;
2: Use a mallet to drive a wooden wedge of the corresponding diameter at the drill hole;
3: Install the skirting board, and nail iron nails where there are wedges (if the nails are not wooden skirting boards, drill holes in the skirting board first, and its position corresponds to the position of the wedges on the wall, be careful not to dislocate). 4: Pay attention to the tight joints at the corners, you can use 45° bevel joints, and the joints should be set on the wooden wedge.
Four, sports wood floor skirting board acceptance criteria
1. The wooden skirting board should be close to the wall.
2. The mouth of the wooden skirting board is straight, and the bottom mouth is tightly pressed against the gap of the wooden floor.
3. If conditions permit, ventilation holes can be made to facilitate ventilation and anti-corrosion.
1. Direct paste method The direct paste method is to apply floor glue to the skirting board in the form of dispensing, and the point distance is about 40-50cm.
2. Fixing the skirting board with nails There are two ways to fix the skirting board with nails: the wedge method is generally used; the other is directly nailed into the wall with cement nails.
Three, wedge method
1: Drill several holes with an impact drill at the root of the wall, usually one hole about 80cm;
2: Use a mallet to drive a wooden wedge of the corresponding diameter at the drill hole;
3: Install the skirting board, and nail iron nails where there are wedges (if the nails are not wooden skirting boards, drill holes in the skirting board first, and its position corresponds to the position of the wedges on the wall, be careful not to dislocate). 4: Pay attention to the tight joints at the corners, you can use 45° bevel joints, and the joints should be set on the wooden wedge.
Four, sports wood floor skirting board acceptance criteria
1. The wooden skirting board should be close to the wall.
2. The mouth of the wooden skirting board is straight, and the bottom mouth is tightly pressed against the gap of the wooden floor.
3. If conditions permit, ventilation holes can be made to facilitate ventilation and anti-corrosion.
