The construction and installation of sports wood flooring manufacturers is a scientific and serious matter. Any problems in the installation process may directly affect the final acceptance of sports wood flooring. Therefore, the editor thinks it is necessary to give a simple explanation of several common problems in the installation of sports wood floors, so as to avoid the taboos in the installation of sports wood floors!
The taboos of sports wood floor construction:
1. Empty phenomenon of sports wooden floor
If the material under the wooden floor is not solid, it will give a feeling of being empty. This is mainly caused by the weak keel and the small number of nails. Of course, sometimes it may be that the plate is not strictly checked when purchasing, which causes the plate to shrink, which in turn leads to the feeling of being hollow. To prevent this phenomenon, you must be careful when selecting materials. During the laying process, necessary supervision is required. Once any inappropriate places are found, rework should be requested immediately.
2. The ground is uneven
The unevenness of the base layer or the insufficient quality of the sports wood floor is the main reason for uneven laying. When laying, the construction personnel should be equipped with a spirit level, so that they can be adjusted in time in case of problems. To avoid this problem, in fact, mainly depends on the material. In addition, the insulation layer should be kept dry, the keel should be flat and standardized, and the wooden floor should be protected from moisture.
3. The joints of sports wood floors are not tight
There are two main reasons for the lack of tight seams. One is the material problem. The size of the board is too different, or the corners are not straight or not, which may cause the seams to not be tight. Another important reason is that the builders are not careful enough. During the laying process, we had better be able to supervise the construction on site to ensure the construction specifications.
4. The phenomenon of warping drum found on sports wooden floor
Sports wood floors are not prone to local warping. This is mainly because the floor absorbs a lot of moisture and causes deformation. If the seam between the boards is too small, it will increase the degree of warping. In the process of laying wooden floors, while paying attention to ventilation, we should also pay attention to cleaning up the water on the ground in time.
